Search Results for:
DIY Connecting Power and Speaker Harness
The following picture shows power and speaker harness connections. Always make it sure to observe the correct polarity on the speaker connections if you want to make a harness connection by yourself. Receiver side are described as followed: 1. Red : +12V DC 2. Green/Black : Rear Speaker (-) 3. Green/Black : Rear Speaker (+) 4. Yellow : Memory +12V 5. White/Black : Front Left Speaker (-) 6. White : Front Left Speaker (+) 7. Blu… 4, 105.03, 2, 16, speaker: 15 harness: 7
How to Test Opel CIH Ignition System Adjustment (Opel 1.9 Engine Firing Order)
The following picture is Opel 1.9 Engine Firing Order schematic, if you need information about how to perform an adjustment test in the Opel CIH ignition system. This test is to be performed with the distributor vaccum hoses disconnected and plugged. This Opel 1.9 Engine firing order schematic covers Lower Front Crank Pulley (can be rotated clockwise with a 19mm wrench on bolt to align timing marks), Vaccum Retard (connected to port on brake b… 1, 75.22, 2, 6, opel: 9
How to Guide: Testing The Opel GT Ignition Switch using an Ohm Meter
Since Opel GT has an old circuit design of ignition switch, this condition may lead to internal resistance build up and premature failure. The following guide may help you how to perform an Opel GT Ignition Switch test by using a simple ohm meter. This Opel GT Ignition Switch test is performed in the car or using key to turn: 1. You should check whether the battery ground cable has been disconnected 2. From the steering colum… 0, 53.89, 1, 7, opel: 8
How to Guide: Testing Vaccum Leak Opel 1.9 Intake Manifold
The Opel 1.9L engine draws the carburetors fuel/air mixture through the intake manifold into the cylinder head, past the valves into the combustion chamber. Symptoms such hesitation, stumble or surge pattern of acceleration, inability to idle smoothly below 1100 rpm, a loss of engine torque, and/or you find the idle speed rpm set too high, could be indicating that you have a vaccum leak in your engine. The following guide can be taken and used … 0, 44.91, 1, 5, opel: 6
How-to Circuit: Install Opel GT Protective Ignition Relay
If you need to diy install a protective action for securing your Opel GT ignition switch, and you might install a protective 4-prong 30 amp relay in the starter circuit, the following circuit schematic may guide you for installing this relay. You need to assemble a harness, with 3 short wires, 4 clip ends and 2 eyelet connectors for connecting 3 relay terminals, one solenoid terminal, one round solenoid battery post, and a round ground on the ch… 1, 41.71, 1, 4, opel: 5 harness: 1