Search Results for:
How to Design an Automatic Fuel Level Monitoring-Circuit System in Gas Station Tank
another voltage regulator 7805 IC. This further reduction became necessary because the 4066 IC used can only take and the computer system can also take 5V as input voltage. This article that was issued by Medwell Journal of Engineering and Applied Science aimed to achieve an automatic fuel level computer-monitoring system that will measure the quantity of fuel inside a tank at four different levels representing 4 sensors. It will trigger an ala… 3, 103.65, 3, 15, fuel: 8 level: 7 monitoring: 6
DIY DC Voltage-Monitoring Device for Monitoring Your 12V Battery
ractor, or boat dashboard. You will need these semiconductors to fulfill this purpose: 2pcs LM324, 20pcs of resistors from various Ohms, 8pcs red, yellow,green small/large LEDs, a trimmer, 2pcs 1N4148 diode, 2pcs Zener Diode for each 1N4733 and 1N4737, a connector 2P terminal block and a PCB. This DC voltage-monitoring device provides an early warning of your battery conditions such flat batteries or other embarassing incidents on your car, trac… 1, 83.67, 2, 7, monitoring: 10
Do-It-Yourself Knowing Fuel System Function and Components
This diagram may help you to understand how fuel system components works and how they relate to one another before doing any fuel pressure testing. Fuel Tank: container that holds vehicle’s supply of fuel. Fuel Pump Filter: usually located in fuel tank, prevent foreign particles from reaching the fuel pump. Fuel Pump: mounted in the fuel tank or on the frame which pumps fuel into the fuel system at a constant pressure. Return Line:… 3, 83.37, 1, 35, fuel: 39
Yamaha FJR1300AS Engine Oil Level Check Tips and Guide
If you need to perform an oil level check task on your Yamaha FJR1300AS, the following article may guide you. Since engine oil must be changed, the engine oil level should be checked before each ride. And here are Yamaha FJR1300AS Engine Oil Level Check Tips and Guide: - Place your FJR1300AS bike on the center-stand - Start and warm the engine for several minutes, and then turn it off - Wait a litlle bit second until the oil settles - Then … 3, 79.63, 2, 21, level: 15 engine: 11
How to Remove and Refit Fuel Injector in the EFI System
In the Electronic Fuel Injection (EFI) System Engine Management, it is best to describe the systems by dividing them into two sub system separately, the air inlet system and the fuel system. The following is the figure of fuel rail and injector assembly, which is part of the fuel system in the EFI. And here is the description of the fuel injector figure and how to remove and refit the device: 1. Fuel Inlet 4. Seals 2. Fuel Rail 5. Injecto… 1, 60.85, 1, 26, fuel: 25 engine: 3